I have tested on 2502 w/ MAU, it works fine. Tok 0 was up up while it
connected to MAU. Try to buy old Token Ring NIC and install in your PC,
then you talk w/ Tok 0.
----- Original Message -----
From: "Sam LI" <[EMAIL PROTECTED]>
To: "Hubert Pun" <[EMAIL PROTECTED]>; "Cisco Study Group"
<[EMAIL PROTECTED]>
Sent: Monday, October 30, 2000 12:58 AM
Subject: Re: Very Basic Token Ring Question
> as far as i know, NO
> even you have a MAU , it will take few seconds for your token interface
to
> join the token ring
>
> Sam Li
> CCSI 96009
> ----- Original Message -----
> From: Hubert Pun <[EMAIL PROTECTED]>
> To: Cisco Study Group <[EMAIL PROTECTED]>
> Sent: Sunday, October 29, 2000 4:49 AM
> Subject: Very Basic Token Ring Question
>
>
> > In the lab, I have a token ring interface. It is not connected to
> > anywhere. Is there a way like the Ethernet's "no keepalive" that can
> > make the token ring interface to be "up up" instead of the current
> > situation of "down down"?
> >
> > BTW, is there a similar thing for serial line?
> >
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
