Hi Guys,
in my site there is a Cisco Router 2610 with the following hardware and
software configuration:
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-D-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Tue 17-Aug-99 13:11 by cmong
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
roma uptime is 2 weeks, 5 days, 22 hours, 47 minutes
System returned to ROM by power-on at 10:44:34 UTC Fri Jan 7 2000
System image file is "flash:c2600-d-mz.120-5.T1"
cisco 2610 (MPC860) processor (revision 0x203) with 20480K/4096K bytes of
memory
.
Processor board ...................
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
Basic Rate ISDN software, Version 1.1.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
2 Low-speed serial(sync/async) network interface(s)
4 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
The WIC ( 2 Serial Sync/Async) are busy for two sites, i must do a new site
with a link at 2 Mbit. The configuration hardware ( 2 Low speed serial), of
course, don't support the new link.
With this architecture Can I repalce the WIC Low Speed Serial with the
other WIC Serial (Sync/Async) at 2 Mbit?
Regards,
Carmelo
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
