I found this on cisco's site by inputing %SYS-2-GETBUF, which is the start of
the error and this is what I got:
============================================
IP Routing Protocols
============================================
CSCdk37681
When you use dynamic address translation, the same global inside address
might be used by two or more different inside hosts. In this case, NAT will
not work for these hosts.
Workaround: Clear the translation table.
============================================
CSCdk57801
Corrupted router link state advertisements might cause following error
messages:
%SYS-2-GETBUF: Bad getbuffer , bytes= 65583 -Traceback= 601E3940 603C7684
603C7420 603AAF00 6 0203E48 60203E34 -Process= "OSPF Router", ipl= 0, pid= 61
%SYS-2-GETBUF: Bad getbuffer, bytes= 65583 -Process= "OSPF Hello", ipl= 0,
pid= 2 -Traceback= 601E3940 603C7684 603B4098 603AB38C 603AB644 60203E48
60203E34
Workaround: Reload the router.
============================================
There were a couple more that were in this statement but I think these 2 are
suited for your problem. Hope I helped...
Mark Z. ~ CCNA, CCDA, 1/2-NP (oh so close)
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]