There's a lot more to this than just typing what I tell you in examples.
Your VTP configuration must be setup on the switch side and the MSFC side.
And yes MLS is enabled at the global level but not at the interface level.
Would you like the URL's to VTP Configuration too?
Patrick
-----Original Message-----
From: Ben Hockenhull [mailto:[EMAIL PROTECTED]]
Sent: Monday, December 04, 2000 11:22 PM
To: Greene, Patrick
Cc: [EMAIL PROTECTED]
Subject: RE: More on VLANs
At 5:22 PM -0500 12/4/00, Greene, Patrick wrote:
>
>
>You need to enable routing for that VLAN interface with the mls command.
>
>
>Example
>interface vlan 200
>ip address 10.1.1.1 255.255.255.0
>mls rp vtp-domain <vtp_domain_name>
>mls rp ip
Hmmm. According to the docs, MLS is enabled by default on the MSFC. I did
enable mls rp ip on the interface and it had no effect. I was unable to
config mls rp vtp-domain as the MSFC muttered something about a null domain.
Ben
--
Ben Hockenhull
[EMAIL PROTECTED]
"Revenge is a dish best served with pinto beans and muffins."
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
