hi all,
This is a veired situation for me. Im having a 7200 with a lot of bri =
ports. One of the ports(BRI 3/4) is shutdown administratively. When I =
use show config command it dosent display the statistics of that port, =
nor am I able to enter into the interface configuration mode (on the =
global config prompt I used " int bri 3/4 " ), it gives the error saying =
" cannot access ISDN channels ". Im "able" to do the same for all the =
other ports except this one using the same command.
Interesting thing here is I get an output when I say " show int bri 3/4 =
". Below is the output !!
sh int bri3/4
BRI3/4 is administratively down, line protocol is down
Hardware is BRI
Internet address is XXXXXXXXXXX
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
LCP Closed
Closed: IPCP
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 18
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
5 packets input, 520 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
5 packets output, 520 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions =
=20
Sounds silly to me.. any bright Ideas ??
Aditya Kedia
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
