Charles,
Here is a cut of a config I use on a 3640 to achive this (This router has 12
MICA modems in slot 1 - the remainder of the PRI timeslots are used for
incoming ISDN calls):
controller E1 2/0
pri-group timeslots 1-31
!
interface Serial2/0:15
ip unnumbered Loopback0
no ip directed-broadcast
encapsulation ppp
isdn switch-type primary-net5
isdn incoming-voice modem
no peer default ip address
ppp authentication pap
ppp multilink
!
interface Group-Async 1
ip unnumbered Loopback0
no ip directed-broadcast
encapsulation ppp
ip tcp header-compression passive
async mode dedicated
peer default ip address pool default
no cdp enable
ppp authentication pap
group-range 33 44
Regards
Adam Burgess
----- Original Message -----
From: "Clare, Charles" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, February 12, 2001 11:10 PM
Subject: 3640 Access server ISDN and PSTN Dial in
>
> Hi All.
>
> Trying to set up a 3640 for ISDN and PSTN Dial in. Have E1 and 30
> Digital Modems. Have set-up a Group-Async for Modem uses and all works
> fine. Question is how do I set up so ISDN callers are handled in the same
> way. Does not seem to be a Group-Dialer command. Does it require me to
> setup 30 Dialler interfaces ?
>
> Thanks in advance.
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]