The syntax of the command is that you put the neighbors ip address and the
interface you want your BGP session to be sourced off of in the command.
So if your neighbor is 200.100.50.25 and you wanted to source your BGP
session off your loopback 0 interface you would enter the command like this:
neighbor 200.100.50.25 update-source Loopback0
Also remember the multihop issue with eBGP neighbors.
Brian Dennis
CCIE #2210 (R&S)(ISP/Dial)
CCSI #98640
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Khalid Jiwani
Sent: Wednesday, February 14, 2001 2:10 PM
To: [EMAIL PROTECTED]
Subject: Update-source in EBGP Sessions
Hi everyone:
If I am establishing an EBGP session with a remote
router, what should be the ip address in the command "
neighbor update-source" of remote peer ? my IP address
or his own IP ? ( Remote neighbor is using me for
transit)
Thanks in Advance
Khalid
__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
