Sorry, I meant user mode, and I already figured out that my problem wasn't a problem at all. Thanks for the time though... ;o) -----Original Message----- From: West, Karl [mailto:[EMAIL PROTECTED]] Sent: Thursday, February 15, 2001 10:49 AM To: Zabludovsky, Mark A; '[EMAIL PROTECTED]' Subject: RE: adding rights to privileged??? Well it depends on what your doing? Are you setting the privilege mode in the router or are you using something like CiscoSecure/Tacacs+ ? Karl -----Original Message----- From: Zabludovsky, Mark A [mailto:[EMAIL PROTECTED]] Sent: Thursday, February 15, 2001 9:58 AM To: '[EMAIL PROTECTED]' Subject: adding rights to privileged??? Hi Group, I wanted to know if it was possible to allow somebody with only privileged level access to a device, to see more than they normally can? Basically, when they type the "show ?" command set, is there a way to allow them to see more parameters than they normally can? Also, if this is possible, would this be the same for everybody that went into the device under privileged mode? Thanks for the help all... Mark Zabludovsky ~ CCNP, CCDA Saint Gobain WAN Team Cisco Network Specialist Work: (610) 341-7678 Mobile: (267) 981-1123 _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]