Each serial link needs to have some sort of clocking at the physical
layer, regardless of your choice of datalink layer protocol. In
addition, each serial link is entirely separate from the others and can
have differing clockrates.
Be sure that you set your clockrate on the DCE side only. The DTE side
does not need to be specified because it is, by definition, listening to
the clock from the DCE.
>>> "." <[EMAIL PROTECTED]> 2/15/01 4:09:37 PM >>>
DCE to DTE no CSU/DSUs
If I connect my routers via serial interfaces using a crossover serial
cable
, do I need to set a clock rate even if I'm running fame relay? If I do
need
to use a clock rate do all the routers need to be set for the same
clock
rate?
Thanks!
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
