Christopher, This is a remote session to a WAN router in Boston. This session is
without PPP, the error I'm getting is "%opening xmodem, read only file system."
Christopher Larson <[EMAIL PROTECTED]> on 02/26/2001 12:18:21 PM
To: Ron Stark/SanDiego/Cymer@Cymer, [EMAIL PROTECTED]
cc:
Subject: RE: Flashing a 2600 series by modem
Is the remote negotiating a ppp session or is it a straight serial
connection? If you are dialing in directly w/o ppp then you will most likely
want to do a reload and a break to get into rommon and then issue the
command xmodem (or whatever it is) and upload the new IOS. If you go this
route, change the speed of the console or aux port first so you are not
uploading an entire image across a 9600 baud port. This will of course take
much longer then a tftp upload, and there will be more downtime.
-----Original Message-----
From: Ron Stark [mailto:[EMAIL PROTECTED]]
Sent: Monday, February 26, 2001 1:49 PM
To: [EMAIL PROTECTED]
Subject: Flashing a 2600 series by modem
Hey gang,
I'm having trouble flashing a 2620 through a modem connection, any help
would be
appreciated.
Ron
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
