I use NAT to change source IP addresses. I can't comment on NATing
destination addresses. However the mother lode of info is:
http://www.cisco.com/warp/public/556/index.shtml
> -----Original Message-----
> From: Warrick FitzGerald [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, February 27, 2001 1:40 PM
> To: [EMAIL PROTECTED]
> Subject: NAT/PAT Question
>
>
> Hi All,
>
> I am trying to configure NAT/PAT where all I am trying to do
> is change to
> Destination Port (DP) of traffic ie. all traffic with a DP of
> 443 and a
> specific destination IP Address (DA) of xxx.xxx.xxx.xxx
> should be NAT'ed to
> xxx.xxx.xxx.xxx with a DP of 444.
>
> Why does this not work ?
>
> ip nat inside source static tcp 65.143.50.10 443 65.143.50.10 444
>
> Thanks
> Warrick FitzGerald
> LiveTechnology International Inc.
>
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct
> and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]