See SPAN and RSPAN on the Cisco WWW site. You need to set up a port as a
SPAN port and then connect your sniffer to that port. It works well...
Hope that helps,
Scott M. Baron
CCNP, CCDP, MCP, CNA
-----Original Message-----
From: Langa Kentane [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, February 28, 2001 4:16 AM
To: '[EMAIL PROTECTED]'
Subject: packet sniffing on a catalyst switch.
How do I setup one of my ports to catch the traffic that goes thru all the
ports on the switch for packet sniffing. I want to put an intrusion
detection sensor on a switch.
Thanks in advance
_________________________________________________________
Langa Kentane | Tel: [011] 290 3218
Security Administrator | Cell: 082 606 1515
[CNA MCSE CCSA CCNA] | www.discoveryhealth.co.za
_________________________________________________________
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
