[ The following text is in the "iso-8859-1" character set. ] [ Your display is set for the "US-ASCII" character set. ] [ Some characters may be displayed incorrectly. ] You cannot use dialer map statement under dialer interface,you have to use dialer string under dialer interface... Not very sure about this but I feel that I have read it in Caslow's book. Regards / Thangavel ----- Original Message ----- From: "Jerry Deer" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, March 12, 2001 9:28 PM Subject: dialer map ip statement - wierd wild wacky stuff going on here - here is a puzzle for you! > ok here is the situation , I have an 804 isdn router in the field that dials > into the host router here at the office lets say the 804 in the field is : > customer1 its ip address is e0 150.5.56.1 and the bri is 150.5.1.56 . In > the host router i have the statements: username customer1 password xxxx > and i have an ip route set up like : ip route 150.5.56.0 255.255.255.0 > 150.5.1.56 ... now here is the wierd part .. under dialer0 i want to add > dialer map ip 150.5.1.56 name customer1 , but the router here will not allow > it and gives me a message like : %Unable to add map, dynamic map currently > exists for ip 150.5.1.56 > so just in case i try to remove it and get:%Unable to add map, dynamic map > currently exists for ip 150.5.1.56 > i have searched the entire config and see no dialer map for 150.5.1.56!!! > any clues?? > Thanks, > Jerry > > > > _________________________________ > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]