Lets see your subnet masks...
----- Original Message -----
From: Navin Parwal <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>
Sent: Tuesday, March 20, 2001 12:03 AM
Subject: A Simple Rip configuration Error
> Hello Everyone ,
> I am facing a problem while configuring RIP on my network , my
network
> is as follows :
> I have two Cisco 2600 series routers which are connected back to back .
>
> 1) On the fisrst Router Cisco2610 my configuration is as follows :
> Ethernet0/0 11.100.10.1
> Serial0/0 200.100.10.1
>
> 2) On the second Router Cisco2620 my configuration is as follows :
> Ethernet0/0 192.168.1.1
> Serial0/0 200.100.10.2
>
>
> I am able to ping from one end of the ethernet of one router to another
> when I configure the routing table statically , but when I am giving the
> following commands for dynamic routing on both of the router :
>
> 1) on 2610 config) router rip
> network 200.100.10.0
>
> 2) on 2620 config) router rip
> network 200.100.10.0
>
> I am not able to view the RIP (R) entries when I give the command show
ip
> route , it shows me only all the directory connected interfaces and gives
me
> a message that gateway not set.
> When I give the command show ip Protocols , it shows me that RIP is
> running .
> I have even changes the network address to the other interfaces
> addresses , that the ethernet interface address of the other side of the
> other router , but still does not display R on the show ip route command
> What could be the error I am making , please let me know .
> I am new on routers and switches .
> thanks,
>
> Navin Parwal
>
>
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]