I just solved the problem.
I needed the sc0 interface to be in vlan 100 - it was in vlan 1 by default?
As I compared the 5500 config against the 6509 configs, I found that on the
6509's the VTP mode was set to transparent and on the 5500 it was set on
server. I simply changed the mode to transparent on the 5500 and at that
point I was able to put sc0 in vlan 100. I can see more vlan 1 on the 5500
trunk now. I think I'm good to go!
Robert
-----Original Message-----
From: Peter Van Oene [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, March 20, 2001 11:30 AM
To: Lopez, Robert
Subject: Re: vlans and trunking
ISL vs Q issues? VTP issues?
*********** REPLY SEPARATOR ***********
On 3/20/2001 at 10:49 AM Lopez, Robert wrote:
>I have the following scenario:
>
>6509-----6509----
>| | |
>| | |5500
>6509-----6509----
>
>The 6509's are in a full mesh (not in picture) and configured as trunks on
>all links. I've added the 5500 and configured two trunk ports. The trunk
>ports are configured on the two 6509's as it relates to the 5500 as well.
>
>When I do a sh trunk on the 5500, I have a question as to why is it that
>only vlan1 shows up in the columns -
>
>Vlans allowed and active in management domain
>
>Vlans in spanning tree forwarding state and not pruned
>
>TIA for any suggestions!
>
>Robert
>
>
>
>Robert M. Lopez
>Network Planning
>Ann Arbor Data Center
>Pfizer Global Research & Development
>
>
>
>
>
>_________________________________
>FAQ, list archives, and subscription info:
>http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
