I have some questions that I'm stuck on.� .� Any tips or help would be greatly appreciated. Q1)� For IBGP, which statement about the next-hop attribute is accurate? A)��� The next-hop is the IP address of the neighbor that sent the update. B)��� The next-hop is the IP address of the neighbor that is one hop closer to the destination C)��� The next-hop is the IP address of the neighbor in the adjacent AS that is closer to the destination. D)��� The next-hop is the IP address of the router that exits this AS. I chose D.� But COLT said it's wrong.� Or is this for EBGP, or NBMA?? � Q2)� For EIGRP rotues to be considered for load balancing and inclusion into the routing table, the route must be: A)��� Local best metric greater than best metric from next-hop router; the variance mulitplier times the local best metric is greater than metric through the same next-hop router. B)��� Local best metric greater than best metric from next-hop router; the variance mulitplier times the local best metric is greater than current metric on this router. C)��� Local best metric greater than best metric from next-hop router; the variance mulitplier times any local metric is greater than metric advertised by any next-hop router. D)��� Local best metric greater than best metric from next-hop router; the variance mulitplier times the local best metric is greater than metric through any next-hop router. I chose D.� But COLT said it's wrong.� I thought for EIGRP to load balance, the variance mulitplies the successor > next-hop router's feasible distance, and the successor has to be greater than the next-hop router's advertisied distance. � Q3)��� Nonbroadcast mulitaccess mode is usually used in a fully meshed netowrk and simulates a broadcast environment.� How do packets get delivered to all remote routers? A)��� Packet replication is handled by the Service Provider B)��� The transmitting router sends the packet to its physical neighbor which copy and flood the packet. C)��� Update packets are sent only once to the mulitcast address 224.0.0.5 D)��� The transmitting router replicates the packets for each neighbor. I chose A, but COLT said it's wrong.� Or is this for point-to-mulitpoint mode? Thanks again for your help in advance. Regards, Hunt Lee IP Solution Analyst Cable and Wireless (Sydney) _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
