Hello,
I had heard a lot about using the loopback interface for router ID for
OSPF, etc... because it never goes down. However, my question is about the
addressing of this interface, and whether I can assign an IP from the same
subnet to a loopback interface on a neighboring router, or I have to assign
a separate subnet on each router? and then how would this subnet be
reachable? I mean how would I advertise it in the routing protocol??
Thank you
Regards,
-------------------------------------------------
Hossam El-Ashkar
[EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
