Not necessarily...
Let says in FXS env.
if at the opposite site you connect four phones with number 2001, 2001, 2003
and 2002, you only need to configure one dial peer, but with destination
pattern using wild card (200.)
regards
Grad
>From: "Michael Bambic"
>Reply-To: "Michael Bambic"
>To: [EMAIL PROTECTED]
>Subject: VOIP questions - studying for CCIE Written [7:77]
>Date: Tue, 10 Apr 2001 13:02:04 -0400
>
>I'm reading the Lammle book on VOIP and it shows a configuration on R1 that
>looks like this:
>
>dial-peer voice 2000 voip
>destination-pattern 2000
>session target ipv4:10.10.10.2
>
>In the diagram the 2000 is a telephone on the otherside of R2 router and
>10.10.10.2 is the IP of the next hop address on R2.
>
>In R2 config it uses a command of:
>dial-peer voice 2000 voip
>destination-pattern 199.
>session target ipv4:10.10.10.1
>
>My question is this,
> Do you have to put in a dial-peer command on the router for every single
>phone connected? What would a sample config look like if you had R1 with
>extensions 1000 through 1999 out 1/0/0 ?
>
>Thanks
>Mike Bambic
>
>[GroupStudy.com removed an attachment of type application/ms-tnef which had
>a name of winmail.dat]
>FAQ, list archives, and subscription info:
>http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=177&t=77
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
