you'd be best to open a ticket with TAC on this one. There may be a bug
report open on that problem, but anything that's service-detrimental is
worthy of their attention. Keep us posted on the result of that.
-e-
----- Original Message -----
From:
To:
Sent: Friday, April 13, 2001 11:58 AM
Subject: LANE and CiscoWorks anomaly [7:499]
> I have a 7206VXR running 12.1(4). When I push an ACL with CiscoWorks
(CW),
> the write back to my CW server kills the LANE client and my users are
> isolated from the WAN until the LANE reestablishes (2-5 minutes). The ACL
> push is actually successful.
>
> I can tftp the ACL from my desktop with Cisco tftp server 1.1 without any
> difficulty.
>
> The 200BX code was upgraded and the problem still exists? Any ideas why
IP
> traffic would kill the LANE? I know that sounds funny...
>
> Must the UNI version from the router to the ATM switch match? If they
don't
> match but must, why would the problem only manifest itself on the
writeback
> to the CW server?
>
> I have noted the proc cpu jumps big with the ACL push - 60% SNMP usage!
>
> But I do this to several (100+) routers a day without failures or pegging
> the load on the router. Am considering downgrading the code to
12.1.1AT1...
>
> Ideas? Suggestions?
>
> Thanks!
>
> Mar 2 15:25:24: %SYS-5-CONFIG: Configured from
> tftp://XXX.XXX.XXX.XXX/pcmdiFSD58964
> Mar 2 15:25:27: %SYS-5-CONFIG_I: Configured from
> tftp://XXX.XXX.XXX.XXX/pcmdiFSD58964 by console
> Mar 2 15:25:36: %SYS-4-SNMP_WRITENET: SNMP WriteNet request. Writing
> current configuration to XXX.XXX.XXX.XXX
> 9
> Mar 2 15:25:40: %LANE-6-INFO: ATM2/0: ILMI prefix add event received
> Mar 2 15:26:04: %LANE-5-UPDOWN: ATM2/0.200 elan XXXXXXXXXX: LE
> Client changed state to down
> Mar 2 15:26:04: %BGP-5-ADJCHANGE: neighbor XXX.XXX.XXX.XXX Down
Interface
> flap
> Mar 2 15:26:08: %LANE-3-NOREGILMI: ATM2/0.200 LEC cannot register
> 35.000103.00027ULD3T
> 38.C8 with ILMI
> Mar 2 15:26:16: %LANE-3-NOREGILMI: ATM2/0.200 LEC cannot register
> 35. 000103.00027ULD3T
> 38.C8 with ILMI
> Mar 2 15:26:27: %LANE-3-NOREGILMI: ATM2/0.200 LEC cannot register
> 47.0006103.00026Y8G88
> 38.C8 with ILMI
> Mar 2 15:26:42: %ATMSSCOP-4-UNMATCHUNIVERSION: (ATM2/0): rcv N(SQ)=0 in
> BeginPdu at UNI 3.1. Please veri
> fy peer UNI version
> Mar 2 15:26:44: %LANE-3-NOREGILMI: ATM2/0.200 LEC cannot register
> 35. 000103.00057DUELT
> 38.C8 with ILMI
> Mar 2 15:27:04: %LANE-6-INFO: ATM2/0: ILMI prefix add event received
> Mar 2 15:27:17: %LANE-5-UPDOWN: ATM2/0.200 elan XXXXXXXXXXXX: LE
> Client changed state to up
>
> ROUTER#sh int atm 2/0.200
> ATM2/0.200 is up, line protocol is up
> Hardware is TI1570 ATM
> Description: link to elan xxxxxxxx
> Internet address is XXX.XXX.XXX.XXX
> MTU 1500 bytes, BW 12000 Kbit, DLY 80 usec,
> reliability 255/255, txload 3/255, rxload 7/255
> Encapsulation ATM-LANE
> 59422 packets input, 34074665 bytes
> 57427 packets output,11690823 bytes
> 0 OAM cells input, 0 OAM cells output
> AAL5 Oversized SDUs : 0
> ARP type: ARPA, ARP Timeout 04:00:00
>
> ROUTER#sh int atm 2/0
> ATM2/0 is up, line protocol is up
> Hardware is TI1570 ATM
> MTU 4470 bytes, sub MTU 4470, BW 155520 Kbit, DLY 80 usec,
> reliability 255/255, txload 3/255, rxload 7/255
> Encapsulation ATM, loopback not set
> Keepalive not supported
> Encapsulation(s): AAL5, PVC mode
> 2048 maximum active VCs, 1024 VCs per VP, 7 current VCCs
> VC idle disconnect time: 300 seconds
> Signalling vc = 1, vpi = 0, vci = 5
> UNI Version = 3.1, Link Side = user
> Last input 00:00:00, output 00:00:00, output hang never
> Last clearing of "show interface" counters 00:01:29
> Queueing strategy: fifo
> Output queue 0/40, 0 drops; input queue 0/75, 0 drops
> 5 minute input rate 4669000 bits/sec, 982 packets/sec
> 5 minute output rate 2210000 bits/sec, 956 packets/sec
> 85627 packets input, 48443618 bytes, 0 no buffer
> Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
> 82029 packets output, 16215942 bytes, 0 underruns
> 0 output errors, 0 collisions, 0 interface resets
> 0 output buffer failures, 0 output buffers swapped out
> ROUTER#
>
> Roger Gore
> CCNA
> CONUS TNOSC
> Ft Huachuca, AZ
> [EMAIL PROTECTED]
> DSN 879-1237
> COM 520 538-1237
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=509&t=499
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
