One easy solution would be to use aliases. So say you have:
1 for r1
2 for r2
3 for r4
4 for r5
You could alias 4 to 3 and 5 to 4.
Access_Server-A#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Access_Server-A(config)#alias exec 4 3
Access_Server-A(config)#alias exec 5 4
Just one of many ways.
Brian Dennis
CCIE #2210 (R&S)(ISP/Dial)
CCSI #98640
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
A.Strobel
Sent: Thursday, April 19, 2001 7:27 PM
To: [EMAIL PROTECTED]
Subject: Reverse telnet [7:1328]
When setting up reverse telnet, it is good to match the connection with the
router number:
1 for r1
2 for r2
6 for r6
What is the trick to have connection 6 to go to r6 even if there is no r5?
Tks.
A. Strobel
____________________________________________________________________
Get free email and a permanent address at http://www.amexmail.com/?A=1
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=1329&t=1328
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]