Am trying to connect two cisco routers each on both side of two speedlan radios and antenna. In place of the second router was a 3com switch before now, and with that connection I can browse the internet. I now replace the switch with a router, the connection from the radio into the router was made using a cross connect rj45 cable. After all configuration, show ip route duplicates all the routes from the first router into the second router. Everything seem okay. But outside the route I cannot browse the internet. Both routers were connected together via the radios through their ethernet interfaces. The questions now is, 1. Can't I connect two routers via a radio through their ethernet interfaces? 2. If the answer is NO, why then was 'show cdp neighbor' showed me the second router, why was the line protocol up, why was the routing table forwarded to my second router? 3. Is there anything I am missingup? Thanks Oletu H. G. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=1647&t=1647 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
