I had a look at the pin-outs and started a hair-brain scheme to make up an extension crossover cable. First problem is a loop between pins 51 and 52, which could possibly have been overcome by snapping off pin 51 or 52 (Dodgy but possible after a few beers to steady the hands- as theyre both on the outside of the connector). Maybe it would work without the loop being taken out? Unfortunately the clocking is on different pins though (23 & 24 instead of 25 & 26), which I would imagine are not even wired through , so I think it's a no-no. Looks like you're looking at soldering both ends, but hey, you've saved yourself the price of ten feet of cable :-) I've not seen inside the DB60 but I should imagine it will be a bit tight. This is what I reckon you need to do anyway. Make a female to female DB15: 1-1 2-4 4-2 9-11 11-9 3-5 5-3 10-12 12-10 6-6 13-13 If you can get into the DB60: Move 26 to 24, and 25 to 23, then snip the loop between 51 and 52. If not you're stuffed! Good luck. I think the amount of time it would take you, you could go and moonlight in McDonalds, then go and buy one instead. If you can get double time you might be able to afford a genuine Cisco cable. :-) Gaz ""EA Louie"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > dude, if you're sharp enough to do the conversion, then here are the pinouts > > http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2501/ > 2500ug/pin.htm (watch URL warp) > There's a link to V.35 there - remember you'll have to change the Winchester > connector to female too... > > btw, this was the first result of a CCO search on "60 pin cable pinouts" > > -e- > ----- Original Message ----- > From: > To: > Sent: Sunday, May 06, 2001 7:18 PM > Subject: Need pinouts to convert Cisco DTE Male cable to DCE female [7:3398] > > > > Hi folks- > > > > I have an abundance of male db-60 to v.35 DTE cables & not enough of the > > DCE > > female cables..I'd like to know if it's possible to convert the DTE > > cables to DCE > > cables without too much hassle if it's too much hassle then I'll just > > purchase a few more DCE's. > > Pinout's ??? > > > > Thanks in advance. > > > > Randy > > ________________________________________________________________ > > GET INTERNET ACCESS FROM JUNO! > > Juno offers FREE or PREMIUM Internet access for less! > > Join Juno today! For your FREE software, visit: > > http://dl.www.juno.com/get/tagj. > > FAQ, list archives, and subscription info: > http://www.groupstudy.com/list/cisco.html > > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=3453&t=3453 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
