Looks like you just have a legacy command hanging around in NVRAM from when
you had the old image in there.
Did you have an IPSEC image before?
Try a Write Mem and reboot.
Regards,
Gaz
""RamG"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> I upgraded the ios to 12.2. When the router start following error
appears.
> Any idea what it is?
>
> Trying R2501 (1.1.1.1, 2001)... Open
> cisco 2500 (68030) processor (revision D) with 16384K/2048K bytes of
memory.
> Processor board ID 01560991, with hardware revision 00000000
> Bridging software.
> X.25 software, Version 3.0.0.
> SuperLAT software (copyright 1990 by Meridian Technology Corp).
> TN3270 Emulation software.
> 1 Ethernet/IEEE 802.3 interface(s)
> 2 Serial network interface(s)
> 32K bytes of non-volatile configuration memory.
> 16384K bytes of processor board System flash (Read ONLY)
>
> ip kerberos source-interface any - {This is the error Invalid input}
> ^% Invalid input detected at '^' marker.
> Press RETURN to get started!
>
> Thanks / RamG
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4439&t=4396
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
