Hi Group,
I just got a 2502, it runs 10.3(16), I configured it and use "copy run
start" to save it, but next time when I boot the box, I still got the
initial configuration dialog:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes]: no
I pressed no, then I found everything I configured before reload is not
there. "show start" still shows correct config but it's not used, for "show
run" gives me blank config.
I know the image is quite old, but without solving this problem I couldn't
upgrade it.
Anyone know what's wrong here?
Thanks,
Jerry
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4618&t=4618
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
