It's solved, the configuration register was set to 0x2142, after I changed to 0x2102, it works fine. Sorry for this, Jerry ----- Original Message ----- From: "Jerry Seven" To: Cc: "[EMAIL PROTECTED]" Sent: Tuesday, May 15, 2001 4:31 PM Subject: 2502: Always initial configutation dialog in the boottime > Hi Group, > > I just got a 2502, it runs 10.3(16), I configured it and use "copy run > start" to save it, but next time when I boot the box, I still got the > initial configuration dialog: > > --- System Configuration Dialog --- > > At any point you may enter a question mark '?' for help. > Use ctrl-c to abort configuration dialog at any prompt. > Default settings are in square brackets '[]'. > Would you like to enter the initial configuration dialog? [yes]: no > > I pressed no, then I found everything I configured before reload is not > there. "show start" still shows correct config but it's not used, for "show > run" gives me blank config. > > I know the image is quite old, but without solving this problem I couldn't > upgrade it. > > Anyone know what's wrong here? > > Thanks, > Jerry > _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=4621&t=4621 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
