Don,
Here is the sh ver from a 3640 in which I am using a 4 port IMA card.
Hope this helps.
Jeff
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-IS56I-M), Version 12.1(5)T7, RELEASE SOFTWARE
(fc1)
TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Mon 16-Apr-01 18:49 by ccai
Image text-base: 0x60008950, data-base: 0x612AA000
ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
ROM: 3600 Software (C3640-IS56I-M), Version 12.1(5)T7, RELEASE SOFTWARE
(fc1)
XXXXXXXXX uptime is 1 week, 20 hours, 12 minutes
System returned to ROM by power-on
System image file is "flash:c3640-is56i-mz.121-5.T7.bin"
cisco 3640 (R4700) processor (revision 0x00) with 121856K/9216K bytes of
memory.
Processor board ID 25049763
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
4 ATM network interface(s)
2 Channelized T1/PRI port(s)
1 Virtual Private Network (VPN) Module(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
****************************************************************************
****************************************************************************
********************************
Good afternoon
I'm having a little difficulty installing my new 4 port ATM/IMA network
module in my 3640 router. The router will not recognize the module.
I've actually swapped three different modules - in different slots - to no
avail - so I don't think it's a hardware issue.
I've tried the following different IOS images:
- 12.1.5T(7) IP/IPX/AT
- 12.2.1 IP/IPX/AT
I'm assuming I don't need an enterprise or 'plus' image (if so that's not
documented anywhere I can find).
The router has 8MB flash and 96MB DRAM (and a 8MB PCMCIA flash card) - its
only other module is a 2E2W with 2 WIC1DSUs installed.
Any ideas????? I'm already running several of these modules in 3660s and
2621s - I know they work!
Don Dettmore
Lead Network Analyst
Fiserv CBS
(407) 513-5236
www.cbs.fiserv.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4685&t=4685
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
