To set a port to send out all traffic from a
particular vlan try the command 'set span
[vlan_number] [module/port]' where vlan_number is the
vlan you want to monitor and module/port is the port
you want to monitor on. This is used to listen to all
traffic going through a particular vlan.
Im not real clear as to what you are trying to do. If
you are trying to have the router route between the
different vlans you have configured you need to use a
trunk line with either ISL or dot1q.
HTH a little.
Ben
--- Group study wrote:
> on 6500, one primary private VLAN 111, 4 secondary
> community private vlan,
> I need to configure one promiscuous port(3/18,
> connected to router) to
> communicate all 4 secondary community private vlan.
>
>
> set pvlan mapping 111 511 3/18
> >cannot add aprivate vlan mapping to a port with
> another private port in
> same ASIC
>
> and I can not "set vlan 111 3/18"
>
> What did I do wrong ? How can I accomplish this ?
>
> Thanks
>
> Ruihai
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]
__________________________________________________
Do You Yahoo!?
Yahoo! Auctions - buy the things you want at great prices
http://auctions.yahoo.com/
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4917&t=4869
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
