Looks like you are missing a neighbour relationship.
I know you have a point-point setup... make sure you do not have an ip ospf
network commands on your interaces.
I had the exact same issue and it was because of the fact that I had left an
ip ospf network point-mulitpoint command left on an interface.
regards
Mike
""Ed Dombrowski"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Below is a routing table from a scenario i am working on. It is for OSPF
> over NBMA in Point-to-Point mode over subinterfaces. It is probably an
easy
> explanation but something i would like to be clear on. My hub location is
> the 2521 which is where this table is from. I have three routers connected
> to it VIA subinterfaces running through a 2523 acting as the switch. I
used
> 192.168.1.0 /30 for the wan addresses. On my remote 2501 connected VIA
> Serial0.102 i added loopback interface 1 ip address 192.168.1.33 /27 as i
> wanted to see how the VLSM address showed up in the route table of the
2521.
> The table is as follows.
>
> 2521#show ip route
> Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
> D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
> N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
> E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
> i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate
> default
> U - per-user static route, o - ODR
>
> Gateway of last resort is not set
>
> 192.168.1.0/24 is variably subnetted, 4 subnets, 2 masks
> O 192.168.1.33/32 [110/1563] via 192.168.1.6, 00:00:17, Serial0.102
> C 192.168.1.8/30 is directly connected, Serial0.103
> C 192.168.1.12/30 is directly connected, Serial0.104
> C 192.168.1.4/30 is directly connected, Serial0.102
> 2521#
>
> My question is why does the address show up as 192.168.1.33/32 instead of
> /27 as i expected. I have dug around through my books and i understand
VLSM
> but cant find a simple explanation as to why this shows up as a /32
address.
> Can anybody explain this to me?
>
> Thanks,
>
> Ed
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5063&t=4448
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
