Hi all;
I have very interesting question that I want to discuss.
I set up an frame-realy Hub and spoke OSPF in my lab environment ( only 1
routing protocol).
r1- Hub (Cisco 2501, Enterprise Plus)
r2- Spoke (Cisco 2513, Enterprise Plus)
r3- Spoke (Cisco 2620, 1S, 1E, 1BRI, IP Plus)
r4- Spoke (Cisco 2511 IP Plus)
r5- Frame Relay Switch
When I was trying to distribute defualt route into OSPF domain by
the following command
" default-information originate always metric 100 metric-type 1
"into R2
The expected result is that, other router in the same OSPF domain will have
default route, metric 100 and type 1.
But I did not have the expected result, only type 2 distribute in other
router, try to adjust bandwidth, etc, .....
When I tried to implement the same configuration but differnet spoke
(2 & 4) the results was expected.
Any comment will welcome!
PS. All the spokes have similiar setting, except the one implement defualt
route ( 2 areas and 1 defualt route)
Vincent Chong
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=6369&t=6369
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]