I think we are missing the question.
IPSec is used for secure transmission and receipt of data between 2 IP
devices. It has NOTHING to do with routing.
I suppose you can say that there needs to be a route for the device/network
at the other end of the tunnel. This is done with the access list in IOS and
PIX software.
As long as the source and destination tunnel IP addresses can communicate,
it does not matter how that route is determined.
Scott Meyer
CCNA, CCDA, MCSE, etc
[EMAIL PROTECTED]
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Circusnuts
Sent: Thursday, June 07, 2001 2:20 PM
To: [EMAIL PROTECTED]
Subject: Re: ipsec question [7:7568]
I believe you should be thinking of DES, when wanting to Encrypt Intranet
traffic. Brian's right, IPSec is more of a public network solution, based
on tunnels...
Of course- we are making all these suggestions based on no scenario :o)
Phil
----- Original Message -----
From: Brian
To:
Sent: Thursday, June 07, 2001 2:03 PM
Subject: Re: ipsec question [7:7568]
> I would suspect, based on the beginning of the acronym, that it is ip
only??
>
> One of its main uses is to route a private network over the public
internet,
> which uses IP.
>
> Brian
>
>
> ----- Original Message -----
> From: "Dar"
> To:
> Sent: Thursday, June 07, 2001 10:56 AM
> Subject: ipsec question [7:7568]
>
>
> > Cant we configure ipsec over routers running any routing protocol ?
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=7656&t=7568
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
