Well,
Better email the group, someone else might benefit from the post.
Just let me know what problems are you having and we will make it work.
G.
""Michael Oaks"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Thanks Gonzalo,
>
> I think I may have enough information to make it work now. If now, I will
> email back.
> Can I email you directly.
>
> Mike
>
> "Gonzalo P." wrote:
>
> > Friend,
> >
> > What you are trying to do is not hard, but, you need to go through a
few
> > steps.
> > I imagine you have an MSFC card inside...
> >
> > - Do a show modules and check if you can see it in slot 15 (and if it is
in
> > state "ok")
> > - Try doing a session 15 (you should get to the router> prompt on the
MSFC
> > - Configure the normal stuff in the router (password, vty, hostname
etc...)
> > (just to check that the router is working fine)
> >
> > Go back to the switch and create the VLANS (maybe you already did this)
> > Add VTP information (if you need it)
> >
> > Go back to the MSFC
> > create the VLANS matching the ones you created in the switch... ( INT
VLAN
> > 3, ETC...)
> > Do a NO SHUT in each one of them,
> >
> > __
> >
> > you will be ready to assign ports to in the Switch to each vlan,
> > communication will flow through the routing card..
> >
> > You can later do more things on the config.. Like adding OSPF or
whaterver
> > you are trying to accomplish.
> >
> > Good Luck
> > -Gonzalo.
> >
> > ""Michael Oaks"" wrote in message
> > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> > > Hi All,
> > >
> > > I am trying to configure a 6509 switch with multiple VLANS. I have
the
> > > configuration guide printed out and believe that I have most of the
> > > configuration correct but I can't get it to communicate with anything.
> > > My question first is; do I have to configure anything in the router
> > > portion of the unit. When ever I try to enter commands in the router
> > > portion, they do not show up in the router configuration. I have been
> > > trying to configure it similar to my 5505 switch, but this does not
seem
> > > to be working. What do I need to do to configure the router section.
> > >
> > > Also, is there anything that needs to be done to link the router to
the
> > > switch or are they automatically linked. I need to have this
configured
> > > and tested by this friday, so any help would be greatly appreciated.
> > >
> > > Thanks,
> > > Mike
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8170&t=8154
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
