In CRB. Concurrent Routing & Bridging can route a protocol on one group of
interfaces & bridge that protocol on another group of interfaces
The traffic on each group of interfaces cannot be switched between groups
unless either of the following conditions are met:
1)Bridged Interfaces are given Network layer address
2)Routed interfaces are put in the bridge group.
Once either of these two conditions are met you are routing and bridging on
the same interface.? My question is ,isn't this is what IRB (integrated
routing & bridging) is ment to achieve.? If so what is the
difference?????????????????
Chris Burnham,
Systems Engineer,
Delphis Consulting Plc.
Tel: +(44) 020 7916 0200
Mob: +(44) 07799403576
[EMAIL PROTECTED]
This e-mail and any files transmitted with it are intended solely for the
addressee and are confidential. They may also be legally privileged.
Copyright in them is reserved by Delphis Consulting PLC ["Delphis"] and they
must not be disclosed to, or used by, anyone other than the addressee. If
you have received this e-mail and any accompanying files in error, you may
not copy, publish or use them in any way and you should delete them from
your system and notify us immediately.E-mails are not secure. Delphis does
not accept responsibility for changes to e-mails that occur after they have
been sent. Any opinions expressed in this e-mail may be personal to the
author and may not necessarily reflect the opinions of Delphis.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8331&t=8331
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
