Hmm I've always seen it when doing a show interface. Sometimes when you do
a show run it will show up in the config. If in doubt go ahead and just put
your config in anyway even though it may not change.
-----Original Message-----
From: Vlade [mailto:[EMAIL PROTECTED]]
Sent: Thursday, June 14, 2001 11:35 AM
To: [EMAIL PROTECTED]
Subject: duplex [7:8553]
Is there a way to check if an interface on a router is running at full or
half duplex? Show int shows the bandwidth but not the mode. Thanks.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8557&t=8553
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
