I have a 2948L3 switch that is connected to a 10/100 hub. The output errors
are very high.After clearing counters I have 100 output errors every ten
minutes. The port is set to autonegotiate and set itself to 100Mb full
duplex. I figured it would autonegotiate to half duplex since its connected
to a hub. Here is a look at the counters:
My question is should I manually set the port to half duplex and would that
remedy these errors?
Or is there something else I should do? Thanks.
Output queue 0/150, 0 drops; input queue 0/150, 0 drops
5 minute input rate 199000 bits/sec, 78 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
46471 packets input, 13423563 bytes, 0 no buffer
Received 78 broadcasts, 17 runts, 0 giants, 0 throttles
100 input errors, 34 CRC, 49 frame, 0 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast
0 input packets with dribble condition detected
3373 packets output, 381430 bytes, 0 underruns(0/0/0)
0 output errors, 54 collisions, 0 interface resets
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8633&t=8633
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
