Dear all exper
pls help me check config when I config dial in router 2501 . show me where is
wrong . because when I dial in from PC It verify username pass end then
disconnect

Thank

router2501#show ru
Building configuration...

Current configuration:
!
version 11.1
service timestamps debug uptime
service timestamps log uptime
service udp-small-servers
service tcp-small-servers
!
hostname router2501
!
aaa new-model
aaa authentication login default tacacs+ local
aaa authentication ppp default tacacs+ local
aaa accounting exec start-stop tacacs+
aaa accounting network start-stop tacacs+
enable secret 5 $1$332U$GrAJLvkQxKKxSmihIz19I/
enable password 7 00071A1507545A
!
username eis password 7 03015218
username tung password 7 03534F1E0808
username tuyen password 7 040C1F130126
username tien password 7 044F1E0808
username t password 7 0107
ip subnet-zero
!
interface Ethernet0
 ip address 192.168.0.200 255.255.255.0
 no ip mroute-cache
 no ip route-cache
!
interface Serial0
 no ip address
 no ip mroute-cache
 no ip route-cache
 shutdown
!
interface Serial1
 no ip address
 no ip mroute-cache
 no ip route-cache
 shutdown
!
interface Async1
 description connected to Dial-inPCs(modem)
 ip unnumbered Ethernet0
 ip tcp header-compression passive
 encapsulation ppp
 async mode interactive
 dialer in-band
 dialer rotary-group 1
!
interface Dialer1
 description connected ti Dial-inPC
 ip unnumbered Ethernet0
 ip tcp header-compression passive
 encapsulation ppp
 peer default ip address pool Cisco2501-Group-1
 dialer in-band
 dialer-group 1
 ppp authentication chap

router2501#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
router2501(config)#int
router2501(config)#interface di
router2501(config)#interface dialer 1
router2501(config-if)#ppp au
router2501(config-if)#ppp authentication pap
router2501(config-if)#as
router2501(config-if)#asy
router2501(config-if)#asy
router2501(config-if)#asy
router2501(config-if)#exit
router2501(config)#asy
router2501(config)#async-bootp ^Z
% Incomplete command.

router2501#show
09:11:29: %SYS-5-CONFIG_I: Configured from console by console ru
Building configuration...

Current configuration:
!
version 11.1
service timestamps debug uptime
service timestamps log uptime
service udp-small-servers
service tcp-small-servers
!
hostname router2501
!
aaa new-model
aaa authentication login default tacacs+ local
aaa authentication ppp default tacacs+ local
aaa accounting exec start-stop tacacs+
aaa accounting network start-stop tacacs+
enable secret 5 $1$332U$GrAJLvkQxKKxSmihIz19I/
enable password 7 00071A1507545A
!
username eis password 7 03015218
username tung password 7 03534F1E0808
username tuyen password 7 040C1F130126
username tien password 7 06121A2F4B
username t password 7 071B
ip subnet-zero
!
interface Ethernet0
 ip address 192.168.0.200 255.255.255.0
 no ip mroute-cache
 no ip route-cache
!
interface Serial0
 no ip address
 no ip mroute-cache
 no ip route-cache
 shutdown
!
interface Serial1
 no ip address
 no ip mroute-cache
 no ip route-cache
 shutdown
!
interface Async1
 description connected to Dial-inPCs(modem)
 ip unnumbered Ethernet0
 ip tcp header-compression passive
 encapsulation ppp
 async mode interactive
 dialer in-band
 dialer rotary-group 1
!
interface Dialer1
 description connected ti Dial-inPC
 ip unnumbered Ethernet0
 ip tcp header-compression passive
 encapsulation ppp
 peer default ip address pool Cisco2501-Group-1
 dialer in-band
 dialer-group 1
 ppp authentication pap
!
router rip
 version 2
 network 192.168.0.0
!
ip local pool Cisco2501_Group-1 192.168.0.17
ip name-server 192.168.0.12
ip classless
tacacs-server host 192.168.0.12
tacacs-server key tung
snmp-server community public RO
!
line con 0
 transport input none
line aux 0

router2501#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
router2501(config)#no ip local pool Cisco2501_Group-1 192.168.0.17
router2501(config)#^Z
router2501#
09:12:37: %SYS-5-CONFIG_I: Configured from console by console
router2501#show int
Async1 is down, line protocol is down
  Hardware is Async Serial
  Description: connected to Dial-inPCs(modem)
  Interface is unnumbered.  Using address of Ethernet0 (192.168.0.200)
  MTU 1500 bytes, BW 9 Kbit, DLY 100000 usec, rely 255/255, load 1/255
  Encapsulation PPP, loopback not set, keepalive not set
  DTR is pulsed for 5 seconds on reset
  LCP Closed
  Closed: ipcp
  Last input 02:18:31, output 02:18:31, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0 (size/max/drops); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/64/0 (size/threshold/drops)
     Conversations  0/1 (active/max active)
     Reserved Conversations 0/0 (allocated/max allocated)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     95 packets input, 2050 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     96 packets output, 2064 bytes, 0 underruns
     0 output errors, 0 collisions, 6 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
Dialer1 is up (spoofing), line protocol is up (spoofing)
  Hardware is Unknown
  Description: connected ti Dial-inPC
  Interface is unnumbered.  Using address of Ethernet0 (192.168.0.200)
  MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec, rely 255/255, load 1/255
  Encapsulation PPP, loopback not set
  DTR is pulsed for 1 seconds on reset
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0 (size/max/drops); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/64/0 (size/threshold/drops)
 --More--


User Access Verification

Username:
Username: eis
Password:

router2501>en
Password:
router2501#show ru
Building configuration...

Current configuration:
!
version 11.1
service timestamps debug uptime
service timestamps log uptime
service udp-small-servers
service tcp-small-servers
!
hostname router2501
!
aaa new-model
aaa authentication login default tacacs+ local
aaa authentication ppp default tacacs+ local
aaa accounting exec start-stop tacacs+
aaa accounting network start-stop tacacs+
enable secret 5 $1$332U$GrAJLvkQxKKxSmihIz19I/
enable password 7 00071A1507545A
!
username eis password 7 03015218
ip subnet-zero
!
interface Ethernet0
 ip address 192.168.0.200 255.255.255.0
 no ip mroute-cache
 no ip route-cache
!
interface Serial0
 no ip address
 no ip mroute-cache
 no ip route-cache
 shutdown
!
interface Serial1
 no ip address
 no ip mroute-cache
 no ip route-cache
 shutdown
!
interface Async1
 description connected to Dial-inPCs(modem)
 ip unnumbered Ethernet0
 ip tcp header-compression passive
 encapsulation ppp
 async mode interactive
 dialer in-band
 dialer rotary-group 1
!
interface Dialer1
 description connected ti Dial-inPC
 ip unnumbered Ethernet0
 ip tcp header-compression passive
 encapsulation ppp
 peer default ip address pool Cisco2501-Group-1
 dialer in-band
 dialer-group 1
 ppp authentication chap
!
router rip
 version 2
 network 192.168.0.0
!
ip local pool Cisco2501_Group-1 192.168.0.17
ip name-server 192.168.0.12
ip classless
tacacs-server host 192.168.0.12
tacacs-server key tung
snmp-server community public RO
!
line con 0
 transport input none
line aux 0
 autoselect during-login
 autoselect ppp
 modem InOut
 modem autoconfigure discovery
 transport input all
 stopbits 1
 rxspeed 38400
 txspeed 38400
 flowcontrol hardware
line vty 0 4
 password 7 0822455D0A16
!
end




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=9017&t=9017
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to