I didnt understand your question completely. Didny you enable trunking on the subinterfaces before inter-Vlan routing. If you didnt, then it will definetely not work. Please clarify your doubt. Imran. --- sagae mitz wrote: > I have a same suggestion as Daniel =) > After you create subinterfaces per vlan on the C2600 > fastEthernet interface, > you must issue the encapsulatin command before you > actually assign the IP > address. > > In my case, that was not the problem. I was doing > InterVlan Routing between > C2600 (with fa interface mod on it) and Cat5505 w/o > RSM. After setting > everything right on Catalyst side, I created the > subinterfaces on fa1/0. > The problem is that C2600 did not perform any > InterVlan routing. I changed > the encap type to dot1q, and suddently it worked. > Very strange.... Any idea > anybody??? > > Thanks [EMAIL PROTECTED] __________________________________________________ Do You Yahoo!? Get personalized email addresses from Yahoo! Mail http://personal.mail.yahoo.com/ Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=9263&t=8797 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]