8/23/2001  12:02am  Thursday

I am trying to hyperterm in to a 2611 router via a USR 14,400 sportster
modem.
The router answers BUT the hyperterm screen is black with a flashing curser
only.
No input can be sent from the keyboard.

output of show line & show run are as follows:

frame_relay_switch#show line 65
   Tty Typ     Tx/Rx    A Modem  Roty AccO AccI   Uses   Noise  Overruns
Int
*   65 AUX 115200/115200- inout     -    -    -      0       0     0/0
-

Line 65, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 115200/115200, no parity, 2 stopbits, 8 databits
Status: Ready, Active, No Exit Banner
Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out
  Modem Callout, Modem RI is CD, Modem Autoconfigure
Modem state: Ready
Modem hardware state: noCTS noDSR  DTR RTS
 TTY NUMBER 65
Parity Error = 0 Framing Error = 0 Receive Error = 0 Overrun = 0
Outcount = 1 totalout = 0 incount = 0 totalin = 0

Special Chars: Escape  Hold  Stop  Start  Disconnect  Activation
                ^^x    none   -     -       none
Timeouts:      Idle EXEC    Idle Session   Modem Answer  Session   Dispatch
               00:10:00        never                        none     not set
                            Idle Session Disconnect Warning
                              never
                            Login-sequence User Response
                             00:00:30
                            Autoselect Initial Wait
                              not set
Modem type is usr_sportster.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are pad v120 telnet rlogin.  Preferred is telnet.
No output characters are padded
No special data dispatching characters
frame_relay_switch#

SHOW RUN (abbreviated):

line con 0
 transport input none
line aux 0
 password cisco
 login
 modem InOut
 modem autoconfigure type usr_sportster
 transport input all
 flowcontrol hardware
line vty 0 1
 password cisco
 login
line vty 2 4
 login
!
end




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=16939&t=16939
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to