Make the serial interfaces on the all of the routers "no ip address" and
"encap frame". Then create sub-ints (remember to make them "point-to-point")
>From there it's just a matter of matching ip addresses and DLCIs from
spoke's sub-ints to hub's ints.
Since your mentioning dce and dte back-to-back, does that mean that you're
using a router as a frame switch simulator (like the Cisco Networking
Academy Labs do)? If so, that's the device that you set the clockrates on, k?
HTH
:-{)]
Mark A. Morenz, MS ED, CCNA, CCAI
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18539&t=18504
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
