nay, not this one, Raul... when I got in via the AUX port, I was very lucky because I guessed the enable password (cisco) and then erased my config. HOWEVER, in this case, I'd suggest to Mr. Xie that he check his hyperterm settings, and set it to 'no flow control'. That, I believe, is one of the simpler attempted solutions to the 'console port broken' problem. If that doesn't fix it, then we can all take guesses at the enable password for him ;-) ----- Original Message ----- From: "Raul F. Fernandez-IGLOU" To: Sent: Wednesday, September 05, 2001 11:31 AM Subject: Re: console port broken, how can i login in router? [7:18651] > Does it havve a configuration on it? If not then the serial interfaces can > SLARP a config on to the router. EALouie is an expert on this and he is part > of the mailing list. > > Raul > ----- Original Message ----- > From: "xie rootstock" > To: > Sent: Wednesday, September 05, 2001 2:09 PM > Subject: console port broken, how can i login in router? [7:18651] > > > > i used aux port and telnet for login, but both only can into > mode, and i > > pressed ctrl+break to revise confreg, but not work, it seems the router > > ignore what i pressed. > > > > any segguestion? _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=18757&t=18757 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]