The switch has nothing to do with OSPF, send your configs
dave
"[EMAIL PROTECTED]" wrote:
>
> I have a 2610 as one peer router and a 3640 as the other peer router. I
> have a 7206 operating as the "frame relay switch" between them. Layer 2
> and Layer 3 are fine because if I use static routes on both peers I can
> ping across the links. However, I must be setting up OSPF dynamic routing
> incorrectly. Most examples show OSPF over "point-to-point" frame relay by
> running OSPF routing processes on all three routers and then putting the
> appropriate network statements on the central router, however the central
> router is only a frame-relay switch in my topology without ip addresses on
> its interfaces. Any ideas would be helpful.
>
> John Squeo
> Technical Specialist
> Papa John's Corporation
> (502) 261-4035
--
David Madland
Sr. Network Engineer
CCIE# 2016
Qwest Communications Int. Inc.
[EMAIL PROTECTED]
612-664-3367
"Emotion should reflect reason not guide it"
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19596&t=19577
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
