Hi everyone,
I was troubleshooting a DDR Backup with ISDN line, here is what happened.
Location 1 was setup to initiate the call, Location 2 to accept it . (I went
trough the config n+1 times).
The connection was never established. I set up the syslog server and
debugging of Q931.
Here is the excerpt out of the syslog.
DISCONNECT pd = 8 callref = 0xC9
Cause i = 0x81D8 - Incompatible destination
Signal i = 0x03 - Network congestion tone on
I put 1 in front of the dial string xxx-xxx-xxxx, and it changed to the
following.
DISCONNECT pd = 8 callref = 0xF4
Cause i = 0x82A2 - No channel available
Signal i = 0x03 - Network congestion tone on
DISCONNECT pd = 8 callref = 0xA2
Cause i = 0x80C1 - Bearer capability not implemented
Signal i = 0x03 - Network congestion tone on
Than I reversed the configuration-Location 2 calling Location 1 - It was
working just the way it supposed to.
I am not an ISDN specialist,so can someone tell me, what my problem with the
first setup was?
Many Thanks,
Michael
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20403&t=20403
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
