I got a question today from a customer who had seen a
%PAGP-5-PORTFROMSTP: error message on his 6509. I explained it was
mostly informational, the device connected to that port was either
disconnected or shutdown.
I then thought I had a good idea, do a "set port host" on our lab
switch on a port connected to a router. My reasoning was that this,
among other things, disables PAGP, auto port channeling, so if I
disconnect a device on a port with port host enabled I should not see
PAGP error messages. Wrong, I still get them
Thought I would throw that out to see if I'm smokin crack with my
logic.
Thanks
Dave
--
David Madland
Sr. Network Engineer
CCIE# 2016
Qwest Communications Int. Inc.
[EMAIL PROTECTED]
612-664-3367
"Emotion should reflect reason not guide it"
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20591&t=20591
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
