hi, with my new found knowledge on this subject...
why don`t you load share your HSRP by using the standby preempt and standby track commands..then simply connect the other ethernet interface to the other switch running HSRP ...job done... ~BTW ....I THINK.....i`m not sure.... List??? CU steve >From: "David C Prall" >Reply-To: "David C Prall" >To: [EMAIL PROTECTED] >Subject: Re: Fastethernet failover [7:21177] >Date: Wed, 26 Sep 2001 22:54:45 -0400 > >I'd start looking at IRB. > >David C Prall [EMAIL PROTECTED] http://dcp.dcptech.com >----- Original Message ----- >From: "Steve Smith" >To: >Sent: Wednesday, September 26, 2001 12:43 PM >Subject: Fastethernet failover [7:21177] > > > > Hey gang this may sound strange but it was just a thought. I have a 3640 > > that has two separate Ethernet interfaces. I have one that runs into one > > of our cats running HSRP. Is there a way to run the second one to the > > other cat as a fail over path? Can this be done with weights or anything > > like that? > > > > Thanks in advance! > > > > Steve _________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=21276&t=21177 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]