I just ran into an interesting problem with the Cat4000 series. Cisco does not support dot1q at this time on that platform. They are coming out with a new IOS but it has not been released yet. You can only run ISL. Lori CCNP -----Original Message----- From: Mcfadden, Chuck [mailto:[EMAIL PROTECTED]] Sent: Friday, November 02, 2001 4:36 PM To: [EMAIL PROTECTED] Subject: RE: Routing on a Stick [7:25025]
It's possible. Make sure the router has a 100BT interface and set up dot1q between the router and the switch. use sub ints on the router to define the Vans and your good to go. I hope this is what you were asking. ccie1ab -----Original Message----- From: Thomas N. [mailto:[EMAIL PROTECTED]] Sent: Thursday, November 01, 2001 10:48 PM To: [EMAIL PROTECTED] Subject: Routing on a Stick [7:25025] Hi All - Had anyone here setup "Routing on a Stick" between a CAT 4006 switch and a Cisco 2600/3600 router using a FastEthernet interface (RJ45) both both the 4006 and the router? Is it possible to set this up? Thanks! Thomas N. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=25769&t=25025 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
