Why don't you use the config script in MRTG and comment out the ones you don't need.
-- -=Repy to group only... no personal=- ""Keith Woodworth"" wrote in message news:[EMAIL PROTECTED]... > Have a 5500 populated with a couple of RSM's, some 24 port FE cards and > another set of cards for doing DSL, dont know cards offhand but they are > 48 port. > > I want to be able to monitor one FE port using MRTG. I did this before but > I think I just monitored the FE port by using the ifIndex of the Vlan as > that was the only port on the vlan. > > The FE port that I want to monitor is also part of a vlan but there are a > couple of other ports associated with that Vlan as well. If I monitor that > Vlan all the ports will be in the graph. I only want one FE port out of > the three on that Vlan to be graphed. > > I have the ifIndex of that FE port but when I use it in the MRTG, MRTG > says that number does not exist. > > An snmpwalk of the switch shows that ifIndex number not there either. > > Here is a snippet of a sh port: > > Port Name Status Vlan Level Duplex Speed Type > ----- ------------------ ---------- ---------- ------ ------ > ----------------- > 11/1 CityLan connected 8 normal full 100 > 10/100BaseTX > > Port Security Secure-Src-Addr Last-Src-Addr Shutdown Trap IfIndex > ----- -------- ----------------- ----------------- -------- -------------- - > 11/1 disabled No enabled 225 > > The ifIndex here is 225. Is this what I can use to monitor that port and > that port only? > > THanks > Keith Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=25722&t=25626 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
