Hi all,
This is my first posting.
I have two questions that I would like you guys to answer.
First question:
I'm connecting two Cisco 2621 by using Serial cable, and I'm
configuring these two routers.
However, when I reload one router, the other also suddenly reload
itself automatically at the same time.
I just guess it may be related to AutoInstall... but I don't know.
Second question:
I'm connecting three Cisco 2621 by using Serial cable like a
triangle, and I have assigned the same network addresses from
192.168.1.0/24 ON PURPOSE. I have not set any routing protocol
and any static route.
e.g. Router1 s0/0=192.168.1.1/24 s0/1=192.168.1.2/24
Router2 s0/1=192.168.1.3/24 s0/1=192.168.1.4/24
Router3 s0/0=192.168.1.5/24 s0/1=192.168.1.6/24
(Router1)-------(Router2)
\ /
\ /
\ /
\ /
\ /
(Router3)
As far as I know, the cable which is connected to a router is
the network itself. If I do the same thing by using ethernet,
the error message 'IP address is overlapping' will be shown.
However, in this case, no message was shown and I could set
the same network address above, and I could ping all three
routers. I have no clue why I could ping without assigning
the different network address and without routing.
sorry for this long statement.
I really appreciate your reading my questions.
Thank you,
Kei
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=33049&t=33049
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
