Hello, Have you tried looking for the problem somewhere else. If you have switches in your environment to which these devices are connected. Check for any errors on the ports to which these devices are connected. Look for the symptoms which would induce latency+errors in LAN enironment, like duplex mismatch, etc.
Tauseef ""beth"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hello All, > I have a user with a full T1 frame relay circuit and a user with a 384k frac > T1 circuit. The problem is the user with full T1 is trying to do a big SQL > query that seems to time out after about 6 minutes of trying but the 384k can > run the same query in about 3 minutes. The full T1 seems responsive and here > is the sh int about 45 mins after router reboot. Any responses would be > greatly appreciated. > **************************************************************************** * > **************************************************************************** * > *********** > Serial0 is up, line protocol is up > Hardware is PQUICC with Fractional T1 CSU/DSU > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, > reliability 255/255, txload 4/255, rxload 3/255 > Encapsulation FRAME-RELAY, loopback not set > Keepalive set (10 sec) > LMI enq sent 321, LMI stat recvd 321, LMI upd recvd 0, DTE LMI up > LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0 > LMI DLCI 0 LMI type is ANSI Annex D frame relay DTE > Broadcast queue 0/64, broadcasts sent/dropped 105/0, interface broadcasts > 50 > Last input 00:00:00, output 00:00:00, output hang never > Last clearing of "show interface" counters 00:53:44 > Input queue: 1/75/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: fifo > Output queue :0/40 (size/max) > 5 minute input rate 22000 bits/sec, 29 packets/sec > 5 minute output rate 29000 bits/sec, 49 packets/sec > 11131 packets input, 1847898 bytes, 0 no buffer > Received 0 broadcasts, 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort > 16526 packets output, 1309436 bytes, 0 underruns > 0 output errors, 0 collisions, 1 interface resets > 0 output buffer failures, 0 output buffers swapped out > 1 carrier transitions > DCD=up DSR=up DTR=up RTS=up CTS=up > > Serial0.1 is up, line protocol is up > Hardware is PQUICC with Fractional T1 CSU/DSU > Internet address is XXX.XX.XX.X/24 > Backup interface BRI0, failure delay 0 sec, secondary disable delay 0 sec > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, > reliability 255/255, txload 4/255, rxload 3/255 > Encapsulation FRAME-RELAY > **************************************************************************** * > ******************************************************************* Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=34266&t=34264 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]