Yes, this applies to ethernet as well. Andy's suggestion-- to tftp the file elsewhere, edit out any mentions of subinterfaces, then tftp the edited file back-- worked like a charm.
- Sean -----Original Message----- From: george gittins [mailto:[EMAIL PROTECTED]] Sent: Friday, February 08, 2002 6:28 AM To: [EMAIL PROTECTED] Subject: RE: Deleting Subinterfaces. [7:34802] does the same apply to ethernet? -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Andy Hoang Sent: Thursday, February 07, 2002 11:05 PM To: [EMAIL PROTECTED] Subject: RE: Deleting Subinterfaces. [7:34802] After you remove the subif and do a "write mem" does the startup-config still shows the subif? If it does, I would tftp the config to a file, edit the file and tftp it back to the router and reload. Just a guess. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Sean Knox Sent: Thursday, February 07, 2002 9:26 PM To: [EMAIL PROTECTED] Subject: RE: Deleting Subinterfaces. [7:34802] The router has been rebooted multiple, but the subif's persist. - Sean -----Original Message----- From: Michael Williams [mailto:[EMAIL PROTECTED]] Sent: Thursday, February 07, 2002 8:51 PM To: [EMAIL PROTECTED] Subject: RE: Deleting Subinterfaces. [7:34802] In general, I believe that when you delete a subinterface (at least on serial lines) the subinterface won't go away until you reboot the router. HTH, Mike W. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=34879&t=34802 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
