Hello everyone... Okay this is the first time I've setup ISDN simulator so bare with me. I basically have TWO cisco routers. A 2503 and a 2522 both of which have a BRI. I also have two Adtran NT1's ACE..on the back of these...there are TWO S/T(Local) ports and to the right of it there is a Network U port. On the side of it there are two LOCAL BUS switches. On one switch it says configuration and switch options are: SHORT and LONG...and the other switch is the Termination: Options are NONE...50....100.
Im assuming the NT1 setup should be like this, but I'm not sure: On the Teltone Simulator: PORT 1 goes to NETWORK port on Adtran ...and then from Adtran S/T port to the BRI port on the Router....however what would be the setup on the adtrans since I get an illuminated ERROR light with the READY light blinking once every second. If anyone knows please let me know thank you Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=35439&t=35439 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]