At 11:50 AM 4/6/02, nntp.groupstudy.com wrote: >I put two FA interfaces into same bridge group, and enable bridge protocol >ieee. There is not IP address configured on the bridge port. But it will >not >bridge any IP traffic unless I disable IP routing on the router
I think that's normal. If you want to bridge IP, you must disable IP routing because IP routing is enabled by default. See this: http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fibm_c/bcfpart1/bcftb.htm#xtocid30 >or use bridge >irb. I was expecting the bridged ports will bridge IP, because there is no >IP configured on these two interface. Can somebody explain why? > >Thanks > >Ruihai ________________________ Priscilla Oppenheimer http://www.priscilla.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=40709&t=40709 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]